Once triggered the lever or lock trim can be removed from the door.
How to get door handle off that has no screws.
Locate the hole underneath the doorknob shaft.
That s because modern door hardware uses a hidden mechanism called a detent to fasten the doorknob that can only be released using a small screwdriver tip or the end of a paper clip depending on your style of hardware.
Push the tip of a narrow screwdriver into the hole.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
The door handle will now slide off.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
Straighten a paper clip and insert it into the hole.
Push this latch in and pull the handle off the door.
Our quick video shows you how si.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
Take your flat philips screwdriver and place it in the gap.
Look for the tiny gap on the side of the door knob.
To remove a door handle without any visible screws start by prying off the cover plate by inserting a flathead screwdriver in the notch on the side of the plate.
If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them.
If the knob has a recessed setscrew turn the setscrew counterclockwise with a correctly sized.
Slide the cosmetic faceplate away from the door.
After applying some pressure you can pull the door knob towards you.
You would be surprised how a simple job like removing a door handle or doorknob can be a frustrating experience if your not prepared.
If you don t see a notch and the cover plate is round try turning the plate counterclockwise to remove it.
You should see a tiny slot or hole.
After you ve unscrewed or loosened the latch tug on the door knob until it pops out of place or disengages from the base also known as the rose.
There should be a small latch near the base of the knob or handle probably on the exterior side of the door.
Insert the tip of a screwdriver and pry off the trim piece.
With some pressure you can move the clip inside.
This is a simple straig.
Depending on the door handle design the faceplate may be able to slide completely off.
Look for a thin slot or a recessed hex head setscrew on the lock side of the doorknob.
