How To Hammer Nail Into Concrete Wall

Tip 2 the correct hammer.

How to hammer nail into concrete wall.

These hooks can support up to 25 pounds and can be pried from the wall when they are no longer needed. A heavy hammer will give the right amount of power and leverage behind it and create the exact force needed for the nail to penetrate the concrete. If the nail stops before its head reaches the surface no amount of pounding will. Reposition the board over the pilot holes aligning the board with the marks on the floor.

With your nail held in place against the wall tap the end of it with your hammer to drive the nail just enough so it s held in place in the wall and you don t need to. Masonry nails should penetrate the surface of the concrete wall to a depth of 3 4 to 1 inch for a solid hold. Proper masonry nails or concrete nail are specifically designed to withstand the pressure of being hammered into a hard set surface. Use at least a two pound hammer.

Hardwall hangers are picture hooks intended specifically for difficult surfaces like concrete block and brick walls. If necessary tap in lightly with a hammer. Be careful not to bend the nails as you drive them. A mash hammer also known as a masonry hammer as a double sided hammer that s much heavier than standard hammers making it the best choice to drive nails into concrete.

Drive the masonry nails directly into concrete walls with a hammer. Insert concrete or masonry nails into the holes and drive them flush to the surface of the wood using a framing hammer. Remove any concrete dust then press the anchor into the hole until it is flush with the surface.