How To Install Trx Wall Mount

The anchor functions as a stopper that prevents the trx trainer from sliding at the top of the door.

How to install trx wall mount.

Mark hole locations with pencil. You ll need to find a stud in your wall an overhead stud or an overhead beam that is 7 to 9 feet off the ground. You can hang the xmount either on the wall or the ceiling. To set up your trx trainer on the doors in your home place one end of the trainer over the door frame and close the door.

Place washer on lag bolt insert through top hole of xmount. Simple yet effective our dynamic line of mounting products heighten the suspension training experience for your members and gives facilities a seamless way of integrating trx into their workouts. This is primarily because even though it does take a few minutes of hassle to install with the xmount you can use all the space you need to do your trx routine. Place xmount with both bolt holes along center of stud.

For those who are really ready to commit the trx has an overhead anchoring system called the x mount. Do not tighten fully as you may need to position lower hole by rotating xmount. The choice is yours. Trx x mount ceiling installation the carabiner of the trx can be suspension trainer or rip trainer shouldn t be clipped directly to xmount.

Able to be fastened to a stud in the ceiling this system allows you to get a full 360 degree range of motion and provides a nice dinner party conversation piece if you decide to set up in the middle of your living room. The xmount is likely the best anchoring solution for the trx. You can also use a trx door anchor which is a nylon suspension that holds the trx trainer in place better. It is recommended to use trx anchor carabiner which is already included in the trx package.

Where should i install my xmount. The reason why you would consider mounting the anchor on the wall would be so that you could take advantage of exercises that require a wall for support.