Installing Led Awning Lights

Connect and tighten the connectors over here and as i ve said before the awning arm is already prepped and cleaned to insure proper adhesion.

Installing led awning lights.

Measure numerous spots below awning track so lights are in a straight line. Do not use strip lights under a vehicle this is the correct way to get. Next we re going to mount the second led light bar to the first. And press again all along.

These very bright rgb pod lights cabels and control box are fully weatherproof. Fitting the led strip light to the av awning. If possible drill hole right at end of light strip and no wire will show. Strips of led lights white and color changing awning lights.

Remove the cover to the two sided tape and center the led on the awning arm. Adding an led light strip to your rv awning buy how to hardwire awning lights led lights mod rv awning led light installation rv led strip lights rvgeek strip light. Under rv led pod light kit with 8 bright lights. A full underlighting kit for your rv or other vehicle.

This strip can be mounted in many places however the best site for mounting the led awning light is just under the awning extrusion that is fastened to the sidewall of your unit please see pictures. Everything is now good. Use a straightened coat hanger to determine where the wiring comes out at in the interior. September 4 2015 i recently decided to add a set of led strip lights to our trailer.

You can also try running your cords through the hole where the awning wiring comes out. Installing led strip lights under your awning or on your awning roller is a great diy project that s not too hard with the right tools. As extra precaution you could put painters tape over drill location before drilling. The best way to fit the led strip light onto the av awning is to use either super glue double sided tape or if the lights have been purchased with drilling holes drilling these onto the metal in the awning.

Installing an rv led strip light. A much harder project is shortening your rv awning which is still very doable. Use new sharp bit and drill with modest pressure. Just measure your awning cut and mount your lights wire them in and you can start enjoying your newly lit outdoor living space.

I was able to do this without any drilling into the tailer by utilizing th.